Enable-IT 8424 Bedienungsanleitung

HYTEC ELECTRONICS Ltd 5 CRADOCK ROAD, READING, BERKS. RG2 0JT, UK Telephone: +44 (0) 118 9757770 Fax: +44 (0)118 9757566 E-mail: sales@

Hytec Electronics Ltd 8424TR/UTM/G/10/2.0 Page 10 48 72 24 36 Lower Threshold reg Chan 3 4A 74 25 37 Upper Threshold reg Chan 3 4

Hytec Electronics Ltd 8424TR/UTM/G/11/2.0 Page 11 5.1 Control & Status Register (CSR) Control Write Address: 0hex D15 D14 D13 D1

Hytec Electronics Ltd 8424TR/UTM/G/12/2.0 Page 12 5.2 Conversion Pointer Read/write Address: 2hex The current conversion address is giv

Hytec Electronics Ltd 8424TR/UTM/G/13/2.0 Page 13 5.4 Interrupt Vector Read/write Address: 8hex The vector register is a 16 bit register

Hytec Electronics Ltd 8424TR/UTM/G/14/2.0 Page 14 5.6 Number Of Conversions Read/write Address: Chex - Ehex The number of conversions r

Hytec Electronics Ltd 8424TR/UTM/G/15/2.0 Page 15 5.8 Digital Potentiometer Data Register Read/write Address: Byte 20hex (Word 10hex)

Hytec Electronics Ltd 8424TR/UTM/G/16/2.0 Page 16 6.2 Set Number of Conversions The number of conversions register (NCO) at address 2hex

Hytec Electronics Ltd 8424TR/UTM/G/17/2.0 Page 17 7. TRANSIENT RECORDER FUNCTION The 8424 unit can be set to run as a Transient Recorder

Hytec Electronics Ltd 8424TR/UTM/G/18/2.0 Page 18 7.3 Upper And Lower Threshold The 16 bit Upper and Lower Threshold registers is loade

Hytec Electronics Ltd 8424TR/UTM/G/19/2.0 Page 19 7.4 Lower Time Stamp Registers Read/write Address: Chan 1=30&32hex, Chan 2=3E&4

Hytec Electronics Ltd 8424TR/UTM/G/2/2.0 Page 2 Revision History The following table shows the revision history for this document. D

Hytec Electronics Ltd 8424TR/UTM/G/20/2.0 Page 20 7.7 Pre-Trigger Delay Register (PTD) Read/write Address: 64hex The PTD allows a pre-t

Hytec Electronics Ltd 8424TR/UTM/G/21/2.0 Page 21 7.10 Digital Inputs And Outputs In Transient Recorder Mode 7.10.1 Start IN/ExTrig Thi

Hytec Electronics Ltd 8424TR/UTM/G/22/2.0 Page 22 7.11 Transient Recorder Results Unit triggered just before pulse Unit triggered just

Hytec Electronics Ltd 8424TR/UTM/G/23/2.0 Page 23 Unit triggered just before pulse but LTH already exceeded so a value of zero is logged f

Hytec Electronics Ltd 8424TR/UTM/G/24/2.0 Page 24 Unit triggered just before pulse but nither LTH or UTH values are reached. In this cas

Hytec Electronics Ltd 8424TR/UTM/G/25/2.0 Page 25 8. ID PROM The word addresses are as below:- Base+80 ASCII ‘VI’ 5649h

Hytec Electronics Ltd 8424TR/UTM/G/26/2.0 Page 26 APPENDIX A I/O Connector – PL2 (50 way) on 8424 ADC Board Pin Signal Pin Signal 1

Hytec Electronics Ltd 8424TR/UTM/G/27/2.0 Page 27 APPENDIX B HYTEC TRANSITION CARD CONNECTIONS FOR THE ADC8424 I/O Connector – 50 way on

Hytec Electronics Ltd 8424TR/UTM/G/28/2.0 Page 28 The Hytec TB8210/8211 Analogue I/O transition card The Hytec TB8210/8211 is a single-wid

Hytec Electronics Ltd 8424TR/UTM/G/29/2.0 Page 29 9202 signal conditioning card The Hytec 8304 Straight-through transition card Straight

Hytec Electronics Ltd 8424TR/UTM/G/3/2.0 Page 3 CONTENTS 1. INTRODUCTION ...

Hytec Electronics Ltd 8424TR/UTM/G/30/2.0 Page 30 APPENDIX C VME64X PIN ASSIGNMENT ON HYTEC 8002 IP CARRIER BOARD FOR ADC8424 ROW A SIG

Hytec Electronics Ltd 8424TR/UTM/G/31/2.0 Page 31 ROWA SIG ROWB SIG ROWC SIG ROWD SIG ROWZ SIG P2.A01 B +12V P2.B01 +5V P2.

Hytec Electronics Ltd 8424TR/UTM/G/4/2.0 Page 4 7.10.5 Clock In...

Hytec Electronics Ltd 8424TR/UTM/G/5/2.0 Page 5 1. INTRODUCTION The Hytec IP-ADC-8424 is an Industry Pack that provides 4 channels of s

Hytec Electronics Ltd 8424TR/UTM/G/6/2.0 Page 6 2. PRODUCT SPECIFICATIONS Size: Single width Industry Pack

Hytec Electronics Ltd 8424TR/UTM/G/7/2.0 Page 7 3. Operating Modes 3.1 Register mode This mode is enabled by setting ARM = ‘1’ (bit 15

Hytec Electronics Ltd 8424TR/UTM/G/8/2.0 Page 8 4. Memory Map A bit in the control register of the 8424 allows selection of either 1Mb m

Hytec Electronics Ltd 8424TR/UTM/G/9/2.0 Page 9 5. Application and Control Registers There are a number of application and control regist