Enable-IT 868 Datenblatt PDF herunterladen (Seite 20)

Module operation SP1ML

20/27 DocID026906 Rev 3

S18 BROADCAST_ADDR

Address: The 8-bit broadcast address, used for broadcast filtering on

received packets.

Values:

Any 8-bit hexadecimal value.

Default: 0xff

S19 FILTER_CRC

Address: Filter packets that have an invalid CRC.

Values:

0 = Disabled, 1 = Enabled

Default: 0

S20 FILTER_SOURCE

Address: Filter packets that do not have a source address that

matches the address specified in register S16.

Values:

0 = Disabled, 1 = Enabled

Default: 0

S21 FILTER_DESTINATION

Address: Filter packets that do not have a destination address that

matches the modules source address specified in register S15.

Values:

0 = Disabled, 1 = Enabled

Default:

S22 FILTER_MULTICAST

Address: Filter packets that do not have a destination address that

matches the multicast address in specified in register S17.

Values:

0 = Disabled, 1 = Enabled

Default: 0

S23 FILTER_BROADCAST

Address: Filter packets that do not have a destination address that

matches the broadcast address in specified in register S18.

Values:

0 = Disabled, 1 = Enabled

Default:

S24 TXRX_LED

General: Enable or disable the TX/RX LED output on module pin 1.

When enabled, the LED output will be flashed when data is sent or

received by the radio.

Values:

0 = Disabled, 1 = Active-Low Open Drain Output, 2 = Push Pull Output

Default:

S26 ESCAPE_SEQ

General: Enable or disable the ‘+++’ escape sequence used to enter

command mode. This configuration is never stored and will be enabled

at module reset.

Values:

0 = Disabled, 1 = Enabled

Default: 1

Table 10. Configuration registers (continued)

# Name Description

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27

Kommentare zu diesen Handbüchern

Keine Kommentare

Enable-IT 868 Datenblatt Seite 20

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Enable-IT 868